Taylor-Dunn B0-T48-48 Taylor Truck T48, Manual

Page: 24 / 196

SAFETY RULES AND OPERATING INSTRUCTIONS
Safety Rules Page 10
Loading and Unloading
•
Do not carry more than the maximum
number of passengers allowed for this
vehicle.
•
Do not exceed the cargo load capacity.
•
Do not load cargo that can fall off.
•
Be careful when handling cargo that is
longer, wider, or higher than this vehicle, be
sure to properly secure all loads.
Parking
Before leaving the vehicle:
•
Set the forward-off-reverse switch to the
` “OFF” position.
•
Turn the key switch to the “OFF” position
and remove the key.
•
If equipped with optional hand parking
brake, set the park brake.
In addition:
•
If parking this vehicle on an incline, turn the
wheels to the curb, or block the wheels.
•
Do not block fire aisles, emergency
equipment, stairways, or exits.
Towing
This vehicle is equipped with a standard automatic
electric parking brake. The brake is automatically
applied when the vehicle is stopped. There is a
parking brake bypass switch located under the
rear passenger seat (see illustration). Place this
switch in the UP position to tow the vehicle (see
note below). This switch should be in the UP
position only while towing the vehicle. The switch
should be placed in the DOWN position
immediately after the towing is completed.
Leaving the switch in the UP position will
discharge the battery.
To tow this vehicle, attach a tow strap to the front
bumper tow-bar.
Use another driver to steer this vehicle while it is
being towed. Be sure the driver uses the brakes
when the towing vehicle slows or stops. Do not
tow the vehicle faster than 5 m.p.h. or its
maximum designed speed, whichever is lower.
If at all possible, this vehicle should be placed on
a carrier, rather than towing.
NOTE: The automatic electric brake is powered
by the vehicles battery. The brake may
not disengage if the battery is severely
discharged. A battery must be installed
to tow the vehicle.
Location of Parking Brake Bypass switch under seat cushion