INTERFACOM, S.A.
I3000100.DOC
3
1. ASSEMBLY (Drawing 1)
The mechanical installation of the TX30 taximeter is very simple due to its small
size 180 x 50 x 32 mm.
It can be built in and also assembled directly on the panel or on any type of
bracket. For the assembly there are anchorages for self threading screws on the
rear part, located on the connector cover, that will enable many assembly
possibilities: wether with two screws directly onto the frontal part of the dash
board or on a support or with a unique screw located in the center of the
connector cover. (See drawing 1)
IMPORTANT:
Notice that to assembly the taximeter onto the frontal part of the
dashboard, you do not need any support: the TX30 taximeter was
designed so that it could be assembled by fixing the connector cover
directly to the dashboard, using screws fixed from the inside of the
cover. Then when the cables have been connected to the taximeter,
it is fitted back into the connector cover and the whole installation is
sealed.
The electrical installation connection outlet on the taximeter can be either on the
rear or on the lower part of the equipment, improving and facilitating assembly. It
is most important that no cable nor connection should be visible.
Try to assemble the taximeter on a rigid support with as little vibration as
possible, as in the long run this can cause a break in the contacts.