Taurus TTA-11241, Instruction Manual, Page: 17 / 24

Adjustment
WARNING! Before performing any adjustment, make sure the belt/disc sander
is unplugged from the power supply and the switch is in the OFF position.
Failure to note this warning could result in serious personal injury.
Adjusting the Belt Tracking
12 ) :
•
Plug in the machine.
(Fig
•
Turn t he switch ON and then
i mmed i a t ely turn it OFF. If the belt
tends to slide off the idler drum or
drive drum, the belt is not tracking
properly.
To adjust Belt Tracking:
•
If the sanding belt
(5)
moves towards
the disc, turn the tracking adjustment
knob (6) counter-clockwise
114
of a
turn.
•
If the
'
sanding belt (5) moves away
from the disc, turn the tracking
adjustment knob
(6) clockwise % of a
turn.
•
T urn the switch ON and then
immediately OFF again, noting belt
movement. Re-adjust tracking knob if
necessary.
Fig.12
Squaring the Worktable to the Sanding Disc:
•
Unplug the machine.
•
Use a combination square to check the angle of the worktable with the sanding disc.
•
If the worktable is not 90° with the disc, loosen the table lock knob (12) and tilt the
table.
•
Adjust worktable square to the sanding disc and tighten the table lock knob
(12)
again.
Note: Move the table further or closer to the sanding disc with the worktable hex
screw
(I) (Fig. 13).
After Sales Support Tel: 1300-355-255
15