2- Installation
2.1 - Removing transit bolts
Proceed as follows:
-Let the water run for a while before connecting the hose.
-Connect the water inlet hose applying the rubber joint provided in the f ittings equipment
bag.
-Position the drainage hose inside a hose of a larger diameter, or rest it well fastened
against any kind of drain at the height indicated.
-Neither of the hoses should be twisted or kinked.
2.) Push with a screwdriver at an angle in the
screw holes until the four spacers (H) fall.
2.2 -Plumbing connection
The "H" connection can only be
applied in those machines f itted
for this (Bithermical).
H- Hot water connection.
C- Cold water connection.
After removing the external packing the drum
must be un-blocked before the machine is
used.
This is done in the following manner:
1.) Unscrew and remove the four screws A-B-
C-D.
3.) It is very important to recover these four
spacers (H) because they could cause damage
if they remain inside the machine and also
because they will be required to move the
m a c h i n e i n t h e c a s e o f m ov i n g h o u s e .
The user will require a tap with a 3/4" gas screwthread outlet and a drain situated
between 50 and 80 cms. above floor level. The watermain pressure must be between 0,4
and 10 bar inclusively.
These must be recovered and kept.
35
English
C
H
Max.80 cm.
Min.50 cm.
D
C
B
A
H
THERMO
C
H
- Use new tubes for connecting to the water supply.
