Taurus RB9.9, Assembly And Operating Instructions Manual

Page: 14 / 52

RB9.9
14
2.3 Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1: Mounting the stabilisers
1. Remove and dispose of the fastener along with the two screws - they are not part of the mounting
kit (see figure 1-1).
⚠
CAUTION:
For the next step, the equipment must be lifted on one side. Use the help of another person to
do this. For additional stabilization, you can use the polystyrene from the packaging material
and place it under the equipment.
2. Mount the rear stabiliser (2) to the main frame (1) using two screws (7 & 7A), four washers (16) and
four spring washers (9) (see fig. 1-2).
3. Remove and dispose of the mounting kit along with the two screws - they are not part of the
mounting kit (see fig. 1-3).
4. Mount the front stabiliser (4) to the main frame (1) using two screws (7 & 7A), four washers (16) and
four spring washers (9) (see fig. 1-4).
5. Now tighten all screws tightly.