Taurus Indoor Cycle IC50, Assembly And Operating Instructions Manual

Page: 12 / 36

IC50
12
Step 2: Assembly of pedals
Screw the pedals (7R, 7L) manually and
very carefully clockwise (respectively
anticlockwise) at first to the pedal crank
arms (62R, 62L). A bit of lubricating
grease or oil facilitates the screwing and
might avoid damages to the thread. The
right as well as the left pedal are marked
with the letters R (= right) or L (= left). The
right pedal crank arm is located at the
same side like the belt cover (69). Please
use appropriate tools (15 mm) to tighten
the pedals.
Step 3: Assembly of handlebar
Put the handlebar post (13) in the
device of the main frame (1) and fix your
adjustment with the adjusting lever (17).
Then remove the pre-mounted safety
stopper (19) and put the handlebar
(11) horizontally on the handlebar post
(13). Bring the safety stopper back into
position and mount the handlebar with
the screw (22) and the adjusting lever
(17). Now you can adjust the handlebar
vertically and horizontally by means of
both adjusting levers.
Please make sure that you do not
exceed the safety lines on the handlebar post, when you do the adjustments.