Taurus HIBRIDO 947183, Manual, Page: 6 / 24

3.2.2. Installing the heater
3.2.2.1. After the heater has been removed from its
packaging, remove the back panel from inside the
back cavity.
3.2.2.2. Place the filled gas cylinder into the back of
the heater with the valve outlet facing outwards.
3.2.2.3. Screw the correct regulator onto the outlet
of the gas cylinder valve clockwise. Turn by hand
only. Do not use a spanner. Screw on until the nut is
fully secured.
3.2.2.4. IMPORTANT TEST for leaks: This must be
carried out in a well-ventilated area, free from any
open flames or other sources of ignition. With the
regulator connected to the cylinder, turn on the gas
cylinder valve 1 and 1/2 turns anti-clockwise. Brush
all hose connections, pipe connections to the gas
valve, regulator connection to the cylinder and gas
cylinder valve with a 50:50 solution of detergent and
water. A stream of bubbles forming is an indica-
tion of a leak. If a leak is found, turn off the cylinder
valve (clockwise), disconnect the regulator from the
gas cylinder and remove the gas cylinder to a cool,
outdoor well-ventilated area. Contact your dealer or
gas supplier for assistance.
DO NOT USE THE HEATER IF A LEAK IS FOUND.
DO NOT USE A NAKED FLAME FOR LEAK TESTING.
DO NOT OPERATE ANY ELECTRICAL EQUIPMENT
IN THE PRESENCE OF A GAS LEAK.
3.2.2.5. After leak-testing has passed, fit the rear
panel onto the heater. It may be necessary to twist
the cylinder slightly to allow the regulator and hose
to fit inside the back panel without kinking the hose.
3.2.2. Using the gas heater
• IMPORTANT: The electric and gas heater cannot
be used together.
The heater can be regulated to three different heater
intensities: 1-LOW, 2-MEDIUM and 3-HIGH. Ignition
mode: piezo ignition.
3.2.2.1. Open the valve on the gas cylinder 1 to 1/2
turns.
3.2.2.2. Press down and turn the control knob to
1-low position and hold for 10 seconds.
3.2.2.3. While still holding the control knob in posi-
tion 1, press the ignition button once or twice until
the burner ignites. Continue to hold the knob for
6. Push the top panel into the front
panel; fasten the left and right side
panel and front panel with screws
supplied.
7. According to arrow keys fasten with
screws; install the back panel and
castors. Following the arrows, insert screws
and tighten, use the nuts to secure the 5
castor wheels to the bottom panel.