Taurus CG3HN/B, Manual

Page: 19 / 88

INSTALLING PROCESS:
 Remove the pan supports, the burner lid and
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
 Take care that the ignition devices and flame
supervision devices are not damaged in this
operation.

Apply the sponge provided around the edge of
the appliance. The thickness of the sponge is
3 mm and the width is 10 mm.

Do not leave a gap in the sealing agent or
overlap the thickness.

Do not use a silicone sealant to seal the
appliance against the aperture. This will ae it
difficult to remove from the aperture in future,
particularly if needs to be serviced.
 Place the bracket (B) over the holes that match
the size of the screw. There are one set of
screws holes in each corner of the hob.
Slightly tighten a screw (C) through the bracket
(B) so that the bracket is attached to the hob,
but so that you can still adjust the position.

Carefully turn the hob back over and then
gently lower it into the aperture hole that you
have cut out.
 On the underneath of the hob, adjust the
brackets into a position that is suitable for your
worktop. Then fully tighten the screws (C) to
secure the hob into position.
GAS CONNECTION:
 This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.
 This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and
natural gas must only be undertaken by a qualified person.

It is the law that all gas appliances are installed by competent persons in accordance with
the current edition of Gas Safety Installation and Use Regulations.
 It is in your interest and that of safety to ensure compliance with the law.