After Sales Support
TEL: 1300 922 271 EMAIL: [email protected]
11
7.2 On/Off switch (Fig. 3 / Item 2)
• Press the green button to switch the saw on.
• Press the red button to switch the machine off.
• Please note: The machine is equipped with a safety switch
to prevent it being switched on again accidentally after a
power failure.
7.3 Blade speed regulator (Fig. 1 / Item 3)
The blade speed regulator allows you to set the blade speed
appropriate to the material to be cut.
7.4 Carrying out internal cuts
1. A feature of this scroll saw is that it allows you to carry
out internal cuts in a panel without damaging it on the
outside or circumference.
Warning! To avoid injury from accidental starting: Before
you remove or change the blade, always set the switch to
„0“ position and pull the power plug out of the socket.
2. To carry out internal cuts in a panel: Remove the blade as
described in Section 6.3.2
3. Drill a hole in the panel in question.
4. Place the panel on the saw table with the drilled hole
above the access hole.
5. Install the blade through the hole in the panel and adjust
the blade tension.
6. When you have completed the internal cuts, remove the
blade from the blade holders (as described in Section
6.3.2) and take the panel off the table.
7.5 Adapter for jigsaw blades (Fig. 8/9)
• Remove the saw blade as described in 6.3.2.
• Now insert the scroll saw blade (a) in the adapter.
• First remove the table insert (18).
• Then hook both adapters (22) on the two saw blade
holders (8/13).
• Insert the saw blade as described in 6.3.2.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting any
cleaning work.
8.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it with compressed
air at low pressure.
• We recommend that you clean the device immediately
each time you have finished using it.
• Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or solvents;
these could attack the plastic parts of the equipment.
Ensure that no water can seep into the device.
8.2 Bearings
Lubricate the bearings of the guide rollers periodically with
high-grade machine grease, but at least after every 25-30
hours in operation.
8.3 Carbon brushes
In case of excessive sparking, have the carbon brushes
checked only by a qualified electrician. Important! The carbon
brushes should not be replaced by anyone but a qualified
electrician.
8.4 Maintenance
There are no parts inside the equipment which require
additional maintenance.
8.5 Ordering spare parts:
Contact our After Sales Support on 1300 922 271 and quote
the following data when ordering spare parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and
can therefore be reused or can be returned to the raw
material system.
The unit and its accessories are made of various types of
material, such as metal and plastic. Defective components
must be disposed of as special waste. Ask your local council.
9. Storage
Store the equipment and accessories out of children’s reach in
a dark and dry place at above freezing temperature. The ideal
storage temperature is between 5 and 30 °C. Store the electric
tool in its original packaging.
