Taurus Alpatec PLEASANT, Manual, Page: 15 / 152

HUMIDITY SETTING FUNCTION:
-Press the humidity setting button (2) to initiate
this function.
-The humidiy range is 40% to 80%. Every time
you press the button the humidity %, shown on
the display, will increase by 5% until reaching
the maximum of 80%, and then it will go back
to 40%.
-Once you have reached the desired humidity
%, stop pressing the button. After around 5
seconds, the display (3) will show the ambient
humidity again and the pilot light will turn off.
That means the desired humidity has been set.
-The appliance will run until the room’s humidity
reaches 2% lower than the one chosen. The
compressor will stop but the fan will keep run-
ning at the set speed.
-When the ambient humidity is 2% higher than
the selected humidity level, the compressor will
start again.
TIMER FUNCTION:
-This function can be used when the dehumidi-
fier is on or in stand by mode.
-When the dehumidifier is on, the running time
of the compressor can be programmed.
-When the dehumidifier is off, it can be pro-
grammed to automatically turn on after the set
time.
-Press the timer button (4) to iniciate this func-
tion.
-The display screen (3) will show the time that is
selected.
-Adjust the desired time by pressing the button
as many times as hours needed (1-24h). Every
press adjusts one hour.
-Once you reach the desired time, stop pressing
the button. After five seconds, the set time is
confirmed.
-The light indicator above will turn on.
-This function will be cancelled when the dehu-
midifier is manually switched on/off, or when
the water tank is full.
FAN SPEED:
-Select the desired fan speed (high or low) by
pressing the fan speed button (5).
-The pilot light will indicate which speed is
selected.
DRAINAGE (WATER TANK):
-When the water tank is full, the full tank light
indicator will turn on. The appliance also emits
a buzzing sound to alert the user.
-When the water tank is full, the operation will
stop.
-Proceed to remove the water tank. Place one
hand on each side of the depression areas to
gently remove the water tank.
-Pour the water out.
-Proceed to place the tank back into the appli-
ance to restart the dehumidifier.
DRAINAGE (CONTINUOUS DRAINAGE):
-If you do not want to empty the water tank ever-
ytime it gets full, you can connect the drainage
pipe provided (H) (inner diameter 10mm) to the
drainage outlet (G) to drain the water continu-
ously.
-To install the pipe, locate the drain outlet (G),
remove the water tank carefully and pull out
the drain cover. Proceed to connect the 10mm
drainage pipe to the outlet.
-The low end of the water pipe must be more
than 10cm lower than the height of the water
outlet.
-The end of the pipe cannot remain in water. It is
highly recommended to install it on a place that
allows the water to drain constantly.
-The water pipe must be kept smooth, otherwise
the water may not be drained properly.
ONCE THE APPLIANCE HAS BEEN USED:
-Stop the appliance pressing the on/off button
(1).
-Unplug the appliance from the mains.
-Clean the appliance.
CARRY HANDLES AND CASTERS:
-This appliance has handles on the side of the
body, which facilitates comfortable transport
(D).
-There are also four casters (C) to facilitate
the transportation of the appliance and avoid
injuries.
CLEANING
-Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.