Taurus Alpatec Babel RC, Manual

Page: 6 / 36

ENGLISH
Tower Fan
BABEL RC
BABEL RCH
DESCRIPTION
A ON/OFF
B Oscillation
C
Speed selector
D Airflow mode selector
E Timer
F Air outlet
G Horizontal base
H Remote control
I Digital display
J Vertical base*
(*) Only available in the model BABEL RCH.
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
-Fully extend the appliance’s power cable before
each use.
-Do not use the appliance if the on/off switch
does not work.
-Do not turn the appliance over while it is in use
or connected to the mains.
-Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
-Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
-Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
INSTALLATION
-Be sure to remove all packaging material from
inside the appliance.
-Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
-Ensure that the appliance is level with respect
to the floor.
-The plug must be easily accessible so it can be
disconnected in an emergency.
ASSEMBLING THE BATTERY/S
-Caution: During the handling of batteries, do
not touch both poles at the same time, as this
will provoke the partial discharge of the stocked
energy therefore affecting longevity.
-Remove the cover of the battery compartment.
-Check that the plastic covering that protects
the battery has been removed (some batteries
are sold with a protective covering)
-Put the battery in its compartment, respecting
the polarity (Fig.3).
-Replace the cover of the battery compartment.
-It is essential that the batteries should always
be the same kind and the same charge. Never
mix alkaline batteries with normal one (Car-
bon-Zinc) and/or rechargeable ones.
ASSEMBLING THE BASE FOR BABEL RC:
-Join the horizontal base parts (Fig.1).
-Fit the base with the body and secure it with
the screws provided.
-Stand the appliance up again so as to check
that the base works properly.
ASSEMBLING THE BASE FOR BABEL RCH:
-Join the horizontal base parts (Fig.1).
-Join the vertical base parts and fix them using
the screws provided (Fig.2).
-Fit the horizontal base with the vertical base
and secure it with the screws provided.
-Stand the appliance up again so as to check
that the base works properly.