11
The manufacturer reserves the right to modify or improve products without prior notice. Any
inaccuracies or errors found in this handbook will be corrected in the next edition.
When opening the packing please check that the product is intact. Please recycle materials in
compliance with current regulations.
This product may only be installed by a qualified fitter. The manufacturer declines all
liability for damage to property and/or personal injury deriving from the incorrect instal
-
lation of the system or its non-compliance with current law (see Machinery Directive).
WARNINGS AND INSTRUCTIONS FOR FITTERS
Congratulations on choosing this Tau product. Please read this handbook carefully.
For the sake of simplicity, the instructions are listed in order of installation.
Please read these instructions carefully before installing the product as they contain
important information concerning safety, installation, use and maintenance.
Anything not expressly specified in this handbook is FORBIDDEN.
Operations not indicated in these instructions may damage the product and put people, animals
and/or and property at risk.
The equipment should be installed only by trained and qualified personnel.
Installation, electrical connections and adjustments must be made according to the rules of
good workmanship and current standards.
Before beginning installation, make sure the product is undamaged.
Do not install the product in explosive environments.
Prior to installing the automation, make all structural modifications in order to ensure safety
distances and protect and segregate areas in which people may be exposed to the risk of
crushing, shearing, dragging or similar dangers. Make sure the existing structure is sufficiently
sturdy and stable.
The safety devices (photocells, sensitive edges, emergency stop devices, etc.) must be installed
according to current legislation and directives, the rules of good workmanship, the installation
area, the operating logic of the system and the forces developed by the powered door or gate.
Fit the signs required by current regulations for identifying dangerous areas. Each installation
must show the identification data of the automated devices in a visible place.
Before connecting to the power supply, make sure the data on the rating plate correspond to
the mains power supply.
Fit a multipole switch/knife switch on the power supply network with contacts opening distance
of at least 3 mm.
Make sure there is a suitable circuit breaker and overcurrent protection device (thermal-magnet
breaker C6) upline from the electrical system.
Connect the automation to an efficient earth system compliant with current safety standards.
The manufacturer declines all liability if incompatible safety and components are installed. Only
use original spare parts to repair or replace the product.
The fitter must provide all the information relative to the automatic, manual and emergency
operation of the automated unit, and give the user the operating instructions.
Keep all the documents concerning the system inside or near the central control unit.
english
