15
K120M
CONTROL BOARD FOR T-ONE3B GEARMOTOR
•
MICROPROCESSOR-CONTROLLED LOGIC
•
INPUT STATUS LED’S
•
LINE INPUT FUSE
•
“PEDESTRIAN GATE” FUNCTION
•
BUILT-IN FLASHING LIGHT CIRCUIT
•
433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)
•
BATTERY CONNECTOR
•
ENCODER SENSOR FOR OBSTACLE DETECTION AND SELF-LEARNING OF TRAVEL
•
ADJUSTABLE DECELERATION
•
DIAGNOSTICS OF MALFUNCTIONS SIGNALLED BY LED
•
EN COMPLIANT AND CERTIFIABLE UP TO 300 KG LEAF
ATTENTION:
- do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
- do not re-use old pre-existing cables.
TESTING
When you have completed the connection:
•
All the green LEDs must be on (each of them corresponds to a Normally Closed input). The go off
only when the controls to which they are associated are operated.
•
All the red LS LEDs must be off (each of them corresponds to a Normally Open input). The light up
only when the controls to which they are associated are operated. Except for the DL3 diagnostics
led which must always be on.
TECHNICAL CHARACTERISTICS
Board power supply
18,5 V AC - 50 Hz
Max motor power DC
50 W - 24 V DC
Fast acting fuse for protection of input power supply 13.5 V AC (F1 - 5x20)
F 16 A
Fast acting fuse for motor protection (F2 - 5x20)
F 10 A
Fast acting fuse for protection of auxiliary circuits 24 V DC (F3 - 5x20)
F 2 A
Motor power supply circuits voltage
24 V DC
Auxiliary device circuits supply voltage
24 V DC
Logic circuits supply voltages
5 V DC
Operating temperature
-20 °C ÷ +70 °C
Box protected to
IP 44
DIAGNOSTICS LED
DL1 (PEDESTRIAN)
PEDESTRIAN button red LED signal
DL2 (OPEN/CLOSE)
OPEN/CLOSE button red LED signal
DL3 (ERR)
ERRORS red LED signal
DL4 (STOP)
STOP button green LED signal
DL5 (PHOTO)
PHOTOCELL green LED signal
DL6 (SENSITIVE EDGE)
SENSITIVE EDGE green LED signal
DL7 (TENSION)
POWER ON (also battery voltage) green
LED signal
ENGLISH
Summary of Contents for K120M
Page 49: ...49 K120M NOTES ...
