7 / EN
Washing Machine / User’s Manual
4.1.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have 10 –
80 liters of water flowing from the fully open tap in 1 minute to have your product run smoothly. Attach a pressure reducing
valve if water pressure is higher.
If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must install the supplied stopper
to the hot water valve before operating the product. (Applies for the products supplied together with a blind stopper group.)
A
WARNING:
Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will
get damaged or the product will switch to protection mode and will not operate.
WARNING:
Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry and water
leakage damages.
Nuts
Screwdriver
Screw
Bushing
Fig c
Fig b
Fig e
Fig d
inlet hose
connector
water inlet
take out
hose
Cap
Fig a
1
Press down the cap, remove the inlet hose connector
as shown in Fig a.
2
Loosen four screws on the inlet hose connector, put
the connector on the tap as shown in Fig b. If the tap
caliber is too large and the connector can not put
on it, loosen four screws and remove the bushing as
shown in Fig c.
3
Tighten four screws as shown in Fig d.
4
Tighten nuts as shown in Fig e.
Fig f
5
Tighten the nut by hand to connect the hose to
washing machine as show in Fig f. Never use a tool
when tightening the nut.
6
When hose connection is completed, check whether
there are leakage problems at the connection points
by opening the taps fully. If any leaks occur, turn
off the tap and remove the nut. Retighten the nut
carefully after checking the seal. In order to prevent
the water leaks and resultant damages, keep the
taps closed when you do not use the product.
4.1.5 Connecting the drain hose to the drain
• Attach the end of the drain hose directly to waste water drain, washbasin or bathtub.
A
WARNING:
Your house will be flooded if the drain hose is dislocated during water draining. Moreover, there is risk of
scalding due to high washing temperatures! In order to prevent such situations and make sure that the product performs
water intake and drain processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground (less than 40 cm
above the ground), water draining becomes more difficult and the laundry may come out excessively wet.
Therefore, observe the heights described in the figure.
40 cm
100 cm
