MOUNTING INSTRUNCTIONS
PL 35-LM2
CLIII IP68
MADE IN ITALY
230 V 50-60 Hz
USE AND MANITENANCE INSTRUCTIONS - LED lighting luminaire
WARNINGS
The following instruction should be applied to proper installatione, use and maintenance of product and serve to guarantee your
safety. Is necessary to preserve them for later consultation.
These instruction must be available and for those who will have the maintenance.
SAFETY NORM
- Switch off the power supply before performing any work on the luminaire, including cleaning.
- Check that the power supply circuit is equipped with a protection device.
- Check that after mounting the device is securely fastened.
- The safety can only be guaranteed by the appropriate use the installation instructions.
- Use the luminaire in the expected position.
- Do not modify the luminaire without contact the manufacturer.
MAINTENANCE
- Before carrying out maintenance operations switch off the system.
- To replace the ballast using the same type, same brand and same power indicated on the data plate, however with the security
mark (IMQ,VDE, UL, etc.).
USE OF THE LUMINAIRE
- We accept no liability for any damage occurred to the product, things and/or people, because incorrect installation and/or
modifications equipment, using accessories that are not suitable compared to the data on the label.
- Is forbidden even partial reproduction of the contained in these instruction and in the installation instruction that accompany
each single device.
Disposal device - RAEE
At the end of the product life is a rejection of that part of the Community Directive 2002/967/EC-RAEE (Waste of Electrical and
Electronic Equipment), should not be treated as household waste and is user’s responsability to dispose of it properly.
To determin the location of the public areas contact the collection agency for collection of waste their municipality.
ATTENTION: ANY MODIFICATION OF THE DEVICE IS FORBIDDEN WITHOUT PERMISSION OF THE MANUFACTURER
The security of the device is guaranteed only compliance with the European Norms electric and instructions contained in this
box, so you need to keep them.
Compliance with this instructions is very important for the correct operation of the appliance and system. The installation must
be made by personal qualified. Disconnect the power supply before carrying out any maintenance and cleaning.
The devices in insulation class I must be connected to the earth circuit of the system.
The light source contained in this lighting fixture can be replaced only by the manufacturer.
IMPORTANT: THE WARRANTY DOES NOT APPLY IN THE FOLLOWING CASES:
- Incorrect installation
- Incorrect connection to the power supply line
- Negligent storage and handling
-Replacement of components with other components not supplied by us
- Tampering
- Lack of or incorrect maintenance
- Failure to comply with the annexed assembly instructions
- Installation in seismic areas or areas subject to strong vibrations
- Damages caused by vandalism
PLEASE NOTE:
Any attempt to intervene on the LEDs not authorised by the manufacturer shall immeditely void the warranty. Therefore, in case
of malfunction, contact the manufacturer for repairing or replacing the product.
GENERAL INSTALLATION RACCOMANDATIONS:
Use only supply cables with double case. Do not enter with single cables.
Use only <HAR> flexible cables of suitable diameter.
DO NOT USE HARD CABLES OR ARMOURED CABLES (Hard cable could effect the IP67 protection)
N.B. : Prior to intervening on the fixture, ensure that the main switch is disengaged.
Tassoni & Pesenti S.r.l.
Tassoni & Pesenti S.r.l. – Tenuta Marcatutto 1 – 20080 – Albairate (MI) – www.tplight.it – [email protected] – tel. +39.02.9465569