Assembly (continued...)
STEP 5: Connect the rear fixed panel
to the bed heads, using the 2 x bolts
on either side. Screw these sections
together but do not completely tighten,
you will tighten the bolts later.
With these sections now assembled,
carefully lift the cot up on its legs.
STEP 4: Insert the front dropside panel, between both headboards.
NOTE: It is best to have assistance at this step to avoid damaging the cot sides,
when inserting the glide pins into the guide channels. The headboards need to be
separated slightly where the glide pins don't damage the timber. If required, un-
tighten the connector bolts, holding the frames together.
Push the upper glide pins into the top of the guide channels on the headboards,
then slide the front panel down slightly on either side. Once the top has the glide
pins are in place, slide the bottom glide pins into the bottom guide channels.
