39
I2
5
I2
4
I2
3
I2
2
I2
1
I2
0
tr
th
s
l
s
e
p
t
p
l
n
o
n
l
it
h
u
h
r
fr
fi
e
s
e
n
e
l
d
e
d
a
c
z
Operator panel
27
Keyswitch
28
Display (on switch-on: Total hours / Error message: see Faults)
29
Brush ON/OFF button ( +/- button for the brush pressure)
30
Vacuum button
31
Cleaning solution ON/OFF button ( +/- button for the dosing quantity)
32
Point cleaning, short-term maximum power consumption
33
Battery fully charged
34
Battery charging, only with the internal battery charger (mains plug plugged
in)
35
Battery/mains unit malfunction
36
Service indicator
37
Slow speed button (used for difficult driving situations)
38
Start/Stop button (loads last used settings)
39
Eco-Function (energy-saving mode)
40
Recovery tank full indicator
41
Battery indicator
Preparation for operation/Operation
Batteries
Safety measures when working with batteries:
Battery connection diagram
Charging procedure (traction block batteries with integrated charging
unit)
Charging procedure (traction block batteries with external charging unit)
• Protective goggles must be worn when working on the
batteries.
• Do not subject batteries to an open flame or heat as there is a
danger of explosion from the electolytic gas present in the
cells!
• No smoking!
• Danger of chemical burns!
Caution:
The battery must always be clean and dry. Do not place any
metallic objects on the battery.
The integrated charging unit is only suitable for
maintenance-free gel traction block batteries.
Start
Stop
Spot
Eco
Start
32
32
32
32
31
31
31
31
33
33
33
33
34
34
34
34
35
35
35
35
36
36
36
36
37
37
37
37
38
38
38
38
39
39
39
39
40
40
40
40
27
27
27
27
28
28
28
28
29
29
29
29
30
30
30
30
41
41
41
41
Caution:
Batteries may only be installed or dismounted by customer
service personnel or specialists approved by JohnsonDiversey
who are aware of all the safety regulations that apply here!
Caution:
Comply with the regulations of the battery manufacturer.
• Switch the machine off using the keyswitch and remove the key.
• Plug the power supply cord into the mains socket.
Check that battery charging display on the control panel.
The yellow indicator lights up permanently until
approx. 90% of the battery capacity has been
reached. After that, the indicator blinks until the
battery is fully charged.
When the charging process is complete, the
green indicator lights up.
• Leave the power supply cord connected to the mains until you use the
machine again. The on-board charger unit automatically monitors and
charges the batteries. The energy consumption in the mode is limited to a
few milliwatts.
If a fault occurs during the charging process as
the result of a defect in the charging unit, an
interruption of a cable or a defective battery cell,
the red indicator will light up.
In the case of a fault, refer to Page 44.
• Switch the machine off using the keyswitch and remove the key.
• Press the Emergency Stop button.
• Stecken Sie das externe Batterieladegerät an den Ladestecker ein.
• Starten Sie das Batterieladegerät.
Ladestecker
Charging plug
