66
End of operation
Removing and cleaning the squeegee
Empty and clean the recovery tank and fresh water tank
Empty the recovery tank and fresh water tank
• Switch off the water pump.
The cleaning solution supply is
stopped.
• Allow the suction unit to run further so that the remaining
water will be sucked out.
• Switch off the suction unit.
The suction motor is switched off.
• Switch the machine off (ON/OFF)
and pull the power supply cord out of
the mains socket.
• Lock the machine in the vertical posi
-
tion.
• Wind the mains cord around the cable hook.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
• Open the cover of the brush housing
by loosening the side latches.
• Turn the four yellow clips to the left to
loosen the squeegees.
• Turn the machine onto the side to re
-
move the squeegees.
1
2
• Wash out the squeegees under run
-
ning water.
Notice:
Check the condition of the suction lips be
-
fore the installation.
Bristles that are too short or damaged suc
-
tion lips will impair the cleaning result!
• Reinstall the squeegees into the noz
-
zle body.
In doing this, note that the front and
rear squeeges are different. The po
-
sition is shown on the upper side of
the squeegees. (FRONT + REAR)
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation
-
al regulations.
Notice:
When draining the recovery tank, the reg
-
ulations of the detergent supplier regard
-
ing personal protective equipment must be
observed.
• Remove the tank from the machine
by pulling on the tank unlocking de
-
vice (1).
• Hold the tank (2) with the other hand
so that it does not fall out of the hold
-
er when unlocked.
• Pull the solution tank out of the hold
-
er.
• Empty the soiled solution from the
tank through the opening provided on
the rear of the tank.
2
1
