16
The moisture contebt of the foam is measured as a percentage by volume.
The switch position of the dosage control unit and the product dosage defines
the amount of moisture within the foam, which affects the drying time of the
carpet.
Beginning work
End of operation
Emptying foam solution and cleaning filter / tank
The disposal of solution must be carried out in accordance with the national
regulations.
Cleaning the sinter head
Cleaning the machine
• Screw the tank cap / dosing cup back on.
• Mount the tool as described in the ergodisc 165/175/200/238/300/400/438/
duo instructions of use.
Caution:
When using the machine for the first time, we recommend
practising handling it on a flat surface in a wide open area until
you feel comfortable with managing the machine.
• Connect the power supply cord to the mains
socket.
The display lights up.
• Turn on the FG 2 by turning the dosing control
unit anti-clockwise.
The foam generator will be activated.
• Select the amount of foam solution with the
dosing control unit (min.1 /max. 4).
Wait until the foam appears under the brush.
• Start up the operation of the single-disk machine as described in the
ergodisc 165/175/200/238/300/400/438/duo instructions of use.
• Release the operation levers.
• Turn off the FG 2 by turning the dosing control
unit clockwise.
• Pull the power supply cord out of the mains socket.
Caution:
The freshly shampooed carpet must not be walked on with
outdoor shoes or shoes with leather soles.
Only use shoes with light colored soles.
• After shampooing, use a web-brush to raise the carpet pile into place.
Allow enough time for the carpet to dry.
• After the carpet is dry, vacuum the cristallized dirt that is left..
5,5L
0
4
3
2
1
0
4
3
2
1
0
4
3
2
1
Caution:
Clogged filters reduce the flow of the cleaning solution. As a
consequence you may damage the floor coating.
• Place a bucket under the outlet opening / filter.
Leave the machine in the working position.
• First open the tank cap / dosing cup and then
the outlet opening / filter.
• Remove the filter.
If the tank cap / dosing cup is not removed, a vacuum may form,
preventing you from emptying the tank.
• Clean the filter under running water using a
brush.
• Thoroughly clean the tank with water.
The filter must be removed.
• Thoroughly clean the spray unit with warm water.
If the cleaning solution dries up, it could cause blockages.
• Insert the filter back into place.
• Remove the sinter head.
• Pull the sinter bushing from the sinter head.
• Clean the sinter bushing under running water
after every use.
Re-attach the sinter bushing to the sinter head.
• Insert the sinter head back into place.
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
• Wipe down the machine with a damp cloth.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
