62
Machine positions
Parking/shifting position
Working position
Transport position
Pad changing position
Prior to commissioning
Insert pad
Before inserting, please check:
• the pad for wear and cleanliness.
Insert one-way fleece dust bag
• Operate the adjusting lever and lift
the steel guide bar slowly upwards
until it is completely upright.
• The foot pedal must be engaged (tool
above).
• Operate the adjusting lever at the
machine handle and lower the steel
guide bar slowly downwards until it is
in a comfortable working position.
• Lower the tool by releasing the foot
pedal (tool below).
• Operate the adjusting lever and fold
the steel guide bar forwards until it
lies on the motor cover.
• Operate the adjusting lever and fold
the steel guide bar forwards until it
lies on the motor cover.
• Put the machine on its back by hold
-
ing one foot against it at the back.
Attention:
Do not use worn or dirty pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade
-
quate cleaning results or even floor dam
-
age.
• Bring the machine into the pad
changing position.
• Remove the pad fixation by untwist
-
ing it to the right.
• Place the pad (1) centrally onto the
driving disc and fix it with the pad fix
-
ation (2).
Attention:
Never use the machine without an inserted
fleece dust bag.
• Remove the cover of the dust bag
container.
• Place the fleece dust bag with the
opening (1) onto the admission pipe
(2).
Make sure that it springs over the
screening (bead).
• Close the dust bag container with the
cover again.
1
2
1
2