3
Never place hands, fingers or feet inside the reel. Although a motor does not power this mower, when the wheels turn
the reel spins and can cut.
Never mow when grass is wet as it can be slippery.
Do not use the reel mower while barefoot or while wearing sandals.
Walk behind, never run, while using reel mower. Always make sure of your footing when using this reel mower.
Never intentionally strike or hit trees, fences, etc. This can cause injuries or severely damage the reel mower
mechanisms.
Make sure your reel mower is in a safe operating condition. Do not attempt to operate this reel mower if damaged.
Contact customer service or have the reel mower repaired by a qualified repair service provider before using.
SAFETY INFORMATION
CARE AND MAINTENANCE
1. Minimum care is required to ensure smooth operation of your mower.
2. To avoid damage to mower or cutting blades, keep area to be mowed free from debris.
3. For best results, regularly apply lubricant to mower’s cutting surfaces, cutting reel axle shaft and wheels.
WARNING
:
Clean any grinding compound or debris from the cutter bar
blade, reel blade, pinions and pawls.
NOTE:
Clean any grinding compound or debris from the cutter bar blade, reel blade, pinions, and pawls.
NOTE:
Use industrial or valve lapping compound between 100 and 240 grit. Lubricate the axle and pinion with a light film
of wheel bearing grease.
Cleaning and Storage:
1. Clean the exterior of the machine thoroughly using a soft brush and cloth before storing. Do not use water, solvents
or polishes.
2. Turn the mower on its side to clean the blade area.
WARNING:
Do not place hands in the mower near blades. If grass cuttings are compacted in the blade area,
remove using a wood or plastic cleaning tool appropriate for the cleaning of the blades.
3. Store the mower in a dry place. Do not place other objects on top of the mower during storage.
Caution:
Do not overtighten the adjusting screws, as this could damage the cutter bar. Tighten both screws
during final adjustment.
3. Turn the reel blades until the front edge of the cutter bar blade is polished.
Sharpening the cutting blades:
1. Spread a thin layer of lapping compound on the front edge of the reel blades.
2. Adjust the cutter bar so that the blade has light but firm contact across the full width of the cutter bar.
Summary of Contents for 26153
Page 11: ...PARTS DIAGRAM 11 ...
