Real People - Real Solutions Real People - Real Solutions Real People - Real Solutions Real People - Real Solutions
6
Scan Speed:
The scanning speed (or time between scan steps) is adjusted by a rotary control accessible
through a small hole on the side, below the Train/Use switch. A small screw driver may be
placed through the hole and turned clockwise to increase or counter clockwise to decrease
the scan speed. Each scan step is accompanied by a short beep. The delay time after the
first scan step is longer than the delay after the following scan steps. This makes it easier
to select the first location in each group of LED’s.
X-10 Control:
There are 10 codes already programmed into the RELAX 3 for X-10 control of
small appliances. They are preset at House Code I.
IMPORTANT NOTE: To use the X-10 signals, you must have an X-10 Radio Transceiver
(TASH #4168), and each appliance you want to control must be plugged
into an X-10 module (the modules are chosen specifically for the appliance you want
to turn ON/OFF).
The following products are available separately:
4167
Remote Chime
4168
X-10 Radio Transceiver
4160
Lamp Module
4162
Appliance Module
4164
Wall Switch Module
4166
Universal Module
IT IS IMPORTANT THAT YOU READ THE MANUAL THAT COMES WITH
THE X-10 RADIO TRANSCEIVER and MODULES FOR CORRECT SET-UP.
Battery Replacement:
The RELAX 3 uses a 9V battery. The 9V battery supplies the main power for its operation.
When the battery is low, three very short beeps are produced when the single switch is first
pressed. Continued use may result in erratic operation. Replacing the battery will correct
the problem. To replace the battery, slide back the cover in the direction of the arrow and
remove it. Pull the battery out and snap a new battery onto the connector.
