8
TASCAM XS-4
English
3. Modification
/
4. Specifications
3. Modification
3.1. Output level
XS-4 has two MASTER outputs.
MASTER OUTPUT 1 (27): Balanced XLR connectors
MASTER OUTPUT 2 (28): Unbalanced RCA jacks
These output level is set to 0 dBV. These output levels
can be changed to +6dBV with jumpers. (See diagram
below.)
Changes on the Output Level have to be performed
by a qualified technician.
You must be careful when setting up the nominal
output level of the mixer. The "clip" display of the
connected power amplifiers must never remain
permanently lightened up, but do it occasionally by
following the rhythm of the bass signals that are
being played.
NOTE
WARNING
4. Specifications
LINE IN (PGM1-4):
RCA, unbalanced
Input Level:
-10dBV
Input impedance:
50kohm
PHONO IN (PGM1-4)
RCA, unbalanced
Input Level:
-45dBV
Input impedance:
50kohm
MIC INPUT
TRS, balanced
Input Level:
-50dBV ~ -30dBV
Input impedance:
1.5kohm
EXT INPUT:
RCA, unbalanced
Input Level:
0dBV
Input impedance:
20kohm
MASTER OUT 1:
XLR, balanced
Nominal Output Level:
0dBV
Output impedance:
600ohm
MASTER OUT 2:
RCA, unbalanced
Nominal Output Level:
0dBV
Output Impedance:
1kohm
REC OUT:
RCA, unbalanced
Nominal Output Level:
0dBV
Output Impedance:
10kohm
PHONES:
230mW, (at 400ohm)
Frequency Response:
LINE IN:
10Hz to 30KHz, -1.0dB
PHONO IN:
RIAA, +/-0.5dB
MIC IN:
10Hz to 30KHz, -1.0dB
Signal to Noise Ratio:
LINE IN:
95dB (IHF A WTD)
PHONO IN:
90dB (IHF A WTD)
MIC IN:
75dB (IHF A WTD)
Total Harmonic Distortion:
LINE IN:
<0.08%
PHONO IN:
<0.09%
MIC IN:
<0.15%
EQ
HIGH:
6.5kHz, +10dB ~ -30dB
LOW:
200Hz , +10dB ~ -30dB
Power Requirement:
100V-240V(50Hz-60Hz)
Power Consumption:
22VA
Dimension (mm):
265(W) x 80(H) x 325(D)
Weight:
3.6kg
All specifications subject to change without notice.
CONFIGURATION.
FACTORY ADJUSTED
TOP VIEW
OUT 2
OUT 1
+6dB
OUT 1 L
OUT 1 R
0dB
0dB
0dB
JUMPER PIN
OUT 2 R
OUT 2 L
