6
TASCAM XS-4
English
2. Features and controls
2.1. Top Panel
1
MIC EQ
2-band EQ for microphone input signal.
2
MIC LEVEL
Adjusts the MIC input signal level.
3
TRIM
Adjusts the input signal level of each PGM.
All input sensitivity adjustment must be done by
very carefully using level meter and/or headphones
as a reference and avoiding that all the red LEDs of
the level meter light up, otherwise input could be
clipped (overload).
4
PGM EQ
2-band EQ for each PGM signal.
5
PHONES LEVEL
Adjusts the headphone output level.
6
MONITOR MASTER/CUE
Selects the way of monitoring in the headphones.
CUE:
This way allows you to monitor the
PGM signals adjusted by cue balance
fader.
MASTER:
This way allows you to monitor the
MASTER signal.
7
CUE BALANCE
Adjusts the balance between PGM 1 and PGM 2 signal in
the headphones.
8
CROSS FADER CURVE
Allows you to adjust the CROSS FADER response curve
from soft (counter-clockwise) to hard (clockwise).
9
CROSS FADER REVERSE
Sets the direction of CROSS FADER operation.
NORMAL:
Moving the CROSS FADER toward A
makes A signal louder and the other
way round.
REVERSE:
Moving the CROSS FADER toward A
makes B signal louder and the other
way round.
0
PHONO/LINE
Selects the input signal (PHONO or LINE) of each PGM.
NOTE
q
PGM FADER
Adjusts the PGM level.
PGM FADER is user replaceable..
w
CROSS FADER
Mixes the PGM 1 and PGM 2 signals.
CROSS FADER is user replaceable. It is possible to set
the CROSS FADER curve and reversal.
e
INPUT LEVEL METER
Indicates the signal level of each PGM.
The lowest LEDs are power on LEDs. When you turn on
the power, these LEDs will be lit up.
LEVEL METER indicates the post EQ signals.
r
CROSSFADER REVERSE indicators
When CROSS FADER is reversed, the LED will light up.
t
MASTER 1 LEVEL
Adjusts MASTER OUT 1 (balanced XLR connectors)
output level.
y
MASTER 2 LEVEL
Adjusts MASTER OUT 2 (unbalanced RCA jacks)
output level.
2.2. How to replace the fader
1. Remove the fader knobs.
2. Remove the four screws from the fader panel surface.
3. Remove the fader panel.
4. Remove the screws that correspond to the fader you
wish to exchange.
5. Unplug the multi-cable connector that connected to
the fader.
6. Replace it with a new one.
7. Plug in the multi-cable connector.
8. Replace the fader with the screws.
9. Replace the fader panel with the screws.
10. Replace the fader knobs.
NOTE
