4
TASCAM US-322/US-366
NOTE
Depending on the computer’s settings, the downloaded zip
file might not have opened automatically. In this case, open
the zip file first and then double-click the disk image file.
3. After the installer launches, follow the instructions on the
screen to proceed with the installation.
Restart the computer to complete installation of the driver.
Connecting other equipment
Front Panel
Guitar
Bass Guitar
Microphone
Headphone
Connect mics to the XLR jacks and guitars to the INPUT 1/L jack.
CAUTION
•
Before turning a
48V
switch
ON
or
OFF
, turn the output
volume down using the
PHONES
and
LINE OUT
knobs on
the front panel. Depending on the mic, loud noises might
be produced and damage could be caused to equipment
or to people’s hearing.
•
Do not connect or disconnect a mic with an input when its
48V
switch is
ON
.
•
Turn
48V
switch
ON
only when connecting a condenser
microphone that requires phantom power.
•
Do not supply phantom power to an unbalanced dynamic
microphone.
•
Some ribbon mics can be damaged by phantom power. If
unsure, do not supply phantom power to a ribbon mic.
•
Before connecting headphones, minimize the volume with the
PHONES
knob. Failure to do so could result in sudden loud
noises that might damage your hearing or cause other harm.
NOTE
On this unit,
INPUT 1/L
and
INPUT 2/R
each have two input
connectors (XLR and TRS). Do not connect signals to both of
these analog input jacks at the same time. If both are connected,
the signal will not be correctly input to the US-322/US-366.
Rear Panel
USB
Computer
Powered speakers or
amplifier and speakers
CD Recorder
Game device
CAUTION
USB 1.1 is not supported.
NOTE
The US-366
DIGITAL IN/OUT
connectors support simulta-
neous 24-bit/192kHz input and output.
Making unit settings
On the bottom panel, the US-366 has DIGITAL IN, LINE I/O
and MODE switches, and the US-322 has a MODE switch.
CAUTION
Before changing these settings, quit the application and
disconnect the USB cable from the unit.
1
DIGITAL IN switch (only US-366)
When using a coaxial cable for digital input, set this to
COAXIAL. When using an optical cable, set this to OPTICAL.
NOTE
You cannot use the coaxial and optical inputs at the same time.
2
LINE I/O switch (only US-366)
Set this to OUTPUT to use the RCA jacks on the rear panel
for output, or set it to INPUT to use them for input.
3
MODE switch
Use to set whether or not the mixed sound input into this
unit and output from the computer are returned to the
computer. Set according to the application.
