Setup
2.5 Computer Software Installation
1. Inside the MOXA folder on your computer run the program “Setup95” to install the
device driver for the Moxa card. After the driver has been installed the “Moxa
Configuration Panel” is displayed.
2. Click the “Add” button and the “Property” Window will appear. Set the parameters
as shown below.
Board Type:
CI-132 Series
INT Vector:
1C0 (Check Box = Checked)
Interrupt No:
10
Base I/I Port Address:
180
3. Leave everything else unchanged and click OK to close the Property window. Then
click OK to close the Moxa Configuration Panel and display a window asking if you
want to restart the computer. Click on the Yes box to restart.
4. When the computer has restarted insert diskette #1 of the TM-D4000 automation
software and run setup to install. Insert diskette #2 when prompted.
5. The installation software will prompt you when the installation is finished. It is not
necessary to restart the computer after installation of the TM-D4000 automation
software.
2.6 TM-D4000 Connection and Configuration
1. Connect the special 9-pin cable supplied with the TM-D4000 to either port on the
MOXA card on one end and connect the other end to the TO HOST port on the back
of the mixer. You must use this supplied cable, a regular 9-pin cable will not work.
2.
Connect a cable from the SMPTE time code output of your recording device to the
TC In connector on the back of the TM-D4000.
3. In the Automation Setup screen of the TM-D4000 set
Communication Speed
to
HIGH
4
and
SYNC SOURCE
to
TC IN
.
If you are using external time code with the TM-D4000, especially if the time code
source is unstable, you may want to increase the
FLYWHEEL
setting to allow the auto-
mation to proceed even when there is a timecode dropout of up to one second.
Alternatively, the internal timecode
generator of the TM-D4000 may be used as
the timecode source for the system.
In this case MTC will be output from the
MIDI OUT port on the back of the mixer
which could be used by a sequencer or
hard disk recorder without SMPTE capability.
It will be necessary to select both the desired
frame rate and start time.
MTC as a
SYNC SOURCE
is not supported in this version of the automation software.
