Advanced Operations
En-67
■
Subnet Mask
Enter the subnet mask address provided by your ISP
(typically
255.255.255.0
).
■
Gateway
Enter the gateway address provided by your ISP.
■
DNS Server
Enter the DNS server address provided by your ISP.
■
Proxy URL
To use a Web proxy, enter its URL here.
■
Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
■
Network Standby
`
On
`
Off
This setting enables or disables control over the network.
When enabled, the
NET
indicator will be dimly-lit while
the AV receiver is in standby mode. Note that the indicator
may not light under certain conditions (
➔
page 50
).
Note
• When set to “
On
”, the power consumption slightly increases in
standby mode.
■
Update Notice
`
Enable
`
Disable
When this setting is enabled, you will be notified if a
firmware update via network is available.
Note
• Selecting “
Never Remind me
” on the notification window will
switch this setting to “
Disable
” (
➔
page 19
).
• For details on the update notification, see “If the “Firmware
Update Available” window appears.” (
➔
page 19
).
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See “
Initial Setup
” (
➔
page 20
).
Note
• This setting cannot be selected if the “
Monitor Out
” setting is set
to “
Sub
”.
Main Menu
Remote Controller Setup
Remote ID
■
Remote ID
`
1
,
2
, or
3
When several other components are used in the same room,
their remote ID codes may overlap. To differentiate the AV
receiver from other components, you can change its remote
ID from “
1
”, to “
2
” or “
3
”.
Note
• If you do change the AV receiver’s remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won’t be able to control it with the remote controller.
Changing the remote controller’s ID
Remote Mode Setup
See “Looking up for Remote Control Codes”
(
➔
page 74
).
Main Menu
Lock Setup
With this preference, you can protect your settings by
locking the setup menus.
■
Setup
`
Locked
`
Unlocked
When “
Locked
” is selected, the setup menus will be
locked and you cannot change any setting.
Remote Controller Setup
1
While holding down
RECEIVER
, press and hold
down
Q SETUP
until the remote indicator lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
1 2 3 4
5
“
Setup
”
Lock Setup
1 2 3 4
5
“
Setup
”
