Connections
En-17
With
u
(Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
u
, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
u
, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver’s remote controller to
control your other
u
-capable components, pointing the
remote controller at the AV receiver’s remote control
sensor instead of the component. You must enter the
appropriate remote control code first (
➔
page 76
).
Note
• Use only
u
cables for
u
connections.
u
cables are supplied
with
u
-capable components.
• Some components have two
u
jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional
u
-capable components.
• Connect only
u
-capable components to
u
jacks. Connecting
other manufacturer’s components may cause a malfunction.
• Some components may not support all
u
functions. Refer to the
manuals supplied with your
u
-capable components.
• While Zone 2/3 is on, the System On/Auto Power On and Direct
Change
u
functions do not work.
Connecting RI Components
1
Make sure that each
u
-capable component is
connected with an analog audio cable (connection
G
in the hookup examples) (
➔
page 16
).
2
Make the
u
connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape deck,
change the Input Display (
➔
page 44
).
L
R
ANALOG
AUDIO OUT
L
R
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock
