12
TASCAM DM-24 2.0 release notes
DM-24 version 2.0—Release notes—I/O setup changes
If an optional IF-AN/DM analog card is fitted, (see
“New output assignment options” on page 7), busses
1 through 8 can be used like post-fader analog effect
sends, with the analog returns fed through the mic/
line inputs and routed through aux 1 and 2 to the ste-
reo buss.
The assignment of a mic/line channel to the aux 1
and 2 busses is made on the
MODULE SETUP
screen as
well as the
AUX SOURCE
screens:
On the
MODULE SETUP
screen, the
ADD. SOURCE
(additional source) parameter for modules 1 through
16 can be set to
RETURN
or
M/L
. This can be set indi-
vidually for each channel.
On the
AUX SOURCE
screens (aux 1 and 2 are linked
on the screen here), the source for channels 1 through
16 can be selected either from
PRE
/
POST
/
RETURN
or
PRE
/
POST
/
M/L
, depending on the
ADD. SOURCE
setting
for the channel:
At the bottom of this screen is a
SETUP
section which
allows you to make a “master” assignment setting.
Use POD 1 to set the parameter to
M/L
and POD 2 to
set the scope of the assignment to
ALL
. When you
highlight the
SET
button and press
ENTER
, channels
1 through 16 will be set to
M/L
(17 through 32 remain
unchanged).
Use the
ASSIGN BUSS
screen to highlight the AUX 1-
2 to stereo assignment section, and press the
ST
key
(
CH ASSIGN
section).
Link aux 1 and 2 using the
LINK/GRP
key to get to
the
ST LINK
screen, move the cursor to aux 1, and
press
ENTER
.
You can use the
AUX 1-2 LEVEL
and
AUX 1-2 PAN/BAL
screens to set the level and pan values for these M/L
inputs, just as for any other channel. These level and
pan settings affect the signals sent to the stereo mas-
ter buss.
Remember that the input level of these signals is
determined by the analog
TRIM
controls.
Digital outputs and Aux sends
Previously, Aux sends had to be paired (1-2, etc.,) in
order to output them from the digital outputs.
