TASCAM ML-4D/OUT-E / ML-4D/OUT-X
13
3
Change device name
Edit the device name.
4
Sampling frequency
Set the sampling frequency.
5
Bit depth
Set the bit depth.
6
Latency setting
Set the latency.
Use the following guidelines to change the latency set-
ting.
Selectable
latency value
Connected network setup guide-
line
1 msec
The transmission route from the
transmitting device to the receiving
device passes through 10 gigabit
switching hub.
2 msec
The transmission speed of the
transmitting device is 100 Mbps.
5 msec
Use this maximum selectable la-
tency value when creating a large-
scale network.
ATTENTION
i
Changing the name of a device will clear audio routing
settings. For this reason, we recommend changing de-
vice names to names that are easy to identify before set-
ting audio routings.
i
Depending on network connection conditions, setting
the latency to a value higher than the guideline might
be necessary.
NOTE
When using a switched (daisy chain) connection, which
does not use a switching hub, set the latency accord-
ing to the number of Dante devices that signals pass-
through as shown below.
Switched (daisy chain) connection example
Passes through 2 devices
Passes through 1 devices
Transmitting
device
Transmitting
device
Receiving
device
Receiving
device
1st device
1st device
2nd device
Specifications
General
Formats and channels
44.1/48/88.2/96
kHz,16/24-bit, 4 channels
Input/output ratings
DATA/DATA+PoE connectors
Connector: RJ-45
Transmission protocol: Dante
Gigabit Ethernet standard: 1000BASE-T (IEEE 802.3ab)
Cables: category 5e or faster STP cables
ANALOG OUT connectors
Connector:
Euroblock (balanced) 3.81 mm pitch (ML-4D/OUT-E)
XLR-3-32 (1: GND, 2: HOT, 3: COLD, ML-4D/OUT-X)
Nominal output levels:
+4 dBu (when Ref. Level not −9 dBFS)
+6 dBu (when Ref. Level set to −9 dBFS)
Maximum output level (switchable):
+15 dBu (Ref. Level: −9 dBFS)
+18 dBu (Ref. Level: −14 dBFS)
+20 dBu (Ref. Level: −16 dBFS)
+22 dBu (Ref. Level: −18 dBFS)
+24 dBu (Ref. Level: −20 dBFS)
Output impedance: 200 Ω or lower
0
0dBu=0.775Vrms
Control input/output
External control connectors
(CONTROL, ML-4D/OUT-E only)
Connectors: Euroblock (balanced) 3.81mm pitch
10V/CONTROL/GND connectors:
Connect variable resistors (10kΩ recommended)
10V
CONTROL
GND
Summary of Contents for Dante ML-4D/OUT-E
Page 50: ...50 TASCAM ML 4D OUT E ML 4D OUT X Bedienungsanleitung...
Page 63: ...TASCAM ML 4D OUT E ML 4D OUT X 63 V P AC AC N AC AC 1 AC AC AC AC AC 100 100 DC 20cm 1U 10cm...
Page 64: ...64 TASCAM ML 4D OUT E ML 4D OUT X V C Y V P AC AC AC N AC AC AC AC AC...
Page 65: ...TASCAM ML 4D OUT E ML 4D OUT X 65 V O AC V 5 1...
