4
7) Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "9P-id",
press DATA (current device will blink)
8) Rotate the DATA DIAL to select the device that best suits your controller and press
SET
9) Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "SPEEd",
press DATA (current status will blink)
10) Rotate the DATA DIAL to select the speed that best suits your environment (9x or
150x normal play speed upon receiving a fast wind command) and press SET
11) Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "JoG-Ed",
press DATA (current status will blink)
12) Rotate DATA DIAL to "on" and press SET
PLAYBACK TIME CODE SOURCE
1)
Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "-tc- cLoSE"
(if display reads "oPEn", proceed to step 3)
2) Press DATA ("cLoSE" will blink), rotate DATA DIAL to "oPEn" - press SET
3) Hold SHIFT and press MENU
▲
or
▼
until you arrive at screen display "21 Pbtc
Auto" ("tc" or "AbS" may already be assigned in place of "Auto")
4) Press DATA ("Auto" will blink)
5) Rotate DATA DIAL to make selection (Auto, AbS, or tc), then press SET
Note: "Auto" is the default condition where ABS time is displayed if no SMPTE code is
detected."AbS" or "tc" may be selected for viewing Absolute Time or SMPTE Time
Code.
PROGRAM NUMBER DURING RECORDING
1)
Press MENU
▲
or
▼
until "P-000" (or some other number) appears to the right of
the counter display
2) Press DATA
3) Using either the DATA DIAL or the RESET key, enter "000" and press SET
4) Hold SHIFT and press SET - a second number "000" will appear to the right
Note: With AUTO ID enabled, the DA-60
MK
II will now automatically enter program
numbers with each new Start ID beginning with "1" while in ASSEMBLE MODE.
PROGRAM NUMBER LOCATE
1)
Press MENU
▲
or
▼
until "P-000" (or some other number) appears to the right of
the counter display
2) Press DATA
3) Rotate the DATA DIAL and select the desired program number
4) Press SET, then LOC 1
PROGRAM NUMBER / RENUMBER
1)
Select EDIT SUB MODE
2) Press ID SELECT until "RENUMBER" is displayed
3) Press EXE - tape will rewind and program number "1" will be written at the first Start
ID the system detects
