14
TASCAM CD-200iL
3 – Preparations
Connecting an iPod or iPhone
This unit can control an iPod or iPhone and output its audio when it is connected to the iPod dock on the front. This unit can also
recharge the iPod or iPhone.
CAUTION
•
When an iPod or iPhone is inserted into this unit’s iPod dock,
the top of the iPod or iPhone is higher than the top of the
unit. Leave 2U or more space open about the unit to prevent
interference with devices installed above it.
•
An iPod or iPhone without a Lightning or Dock connector
cannot be connected to the dock. (See “Connecting external
audio players” on page 16.)
•
Always remove any case from an iPod or iPhone before
connecting it. Connecting with a case on might prevent
complete connection and proper operation and playback.
•
Always use a dock adapter that is suitable for the iPod or
iPhone that you are using. The use of an unsuitable adapter
could damage the connectors of both devices.
•
iPod models that do not support USB mode will not be
recharged when connected to this unit. They will also not
respond to pressing the
PLAY/PAUSE
button on this unit.
When playback operations are conducted from the iPod
itself, analog audio will be output from this unit.
•
Do not connect an iPod or iPhone to this unit using a
Lightning to 30-pin Adapter. If you do so, the playback
sound might not be output and iPod or iPhone control and
recharging might not be possible.
NOTE
•
When an iPod or iPhone is connected to this unit’s iPod
dock, it will be recharged whenever this unit’s power is ON.
When the iPod or iPhone is completely charged, the unit
stops charging. When the unit’s power is OFF, it does not
charge the connected iPod or iPhone.
During charging, a battery icon appears on the iPod or
iPhone screen that shows the charging status. Please see the
operation manual for the iPod or iPhone that you are using
for details.
•
If one iPod/iPhone is connected to the Lightning connector
and another is connected to the 30-pin Dock connector,
the one that was connected last can be controlled and
recharged. The iPod or iPhone that was connected earlier
cannot be controlled or recharged. If this unit, the iPod/
iPhone connected to the Lightning connector and the
iPod/iPhone connected to the 30-pin Dock connector are
all off, when this unit is turned on again, the iPod/iPhone
connected to the Lightning connector will be the one that
can be controlled and recharged.
•
See the TASCAM website (http://tascam.com/ or
http://tascam.eu/ for Europe) for details about compatible
devices.
Opening the iPod dock
8
Connecting an iPod or iPhone with a Lightning
connector
1. Push the iPod dock in the center where it says “PUSH OPEN”
to unlock the iPod dock.
2. Pull the iPod dock out until you can use the Lightning
connector and it locks. Then, raise the backstop.
Backstop
