Tascam 8p Dyna Series, Owner'S Manual

Page: 8 / 104

8
TASCAM SERIES 8p Dyna
Level meter area details
0
OL indicators
These light when input signals reach 3 dB below the
maximum input level.
Check if they are lighting and adjust the input gain.
q
COMP indicators
These indicators light dimly when compressors are enabled.
They light brightly when compressors are activated by input
signals exceeding their threshold values.
w
Level meters
This shows input signal levels after input gain adjustments.
e
Sample clock indicators
These indicators light according to the sampling frequency
currently used by the unit.
When the EXT indicator is lit, the unit is using external clock.
When in sample clock source set up mode, the selected
sample clock source will blink repeatedly at short intervals.
(see “Switching the sample clock” on page 12)
NOTE
i
When operating using external clock, the EXT indicator
will blink when external clock is not being input. When this
happens, the unit will automatically switch to internal clock.
i
When the EXT indicator is blinking (when the unit has
automatically switched to internal clock because external
clock is not being input even though set to use external
clock), that clock frequency will also start blinking if external
clock is input again.