16
TASCAM US-2x2/US-4x4
6 – Using the Settings Panel
Mac Settings Panel overview
1
Status display area
This shows the current status of the software.
Item displayed
Meaning
Software Ver.
This is the software version.
Sample Rate
This shows the sampling frequency.
The sampling frequency can only be set
in the Windows version.
Use the displayed value pull-down menu
to select the frequency (44.1, 48, 88.2 or
96 kHz).
Firmware Ver.
This is the firmware version used by the
connected unit.
Device
This is the name of the connected unit.
(“No Device” is shown when no device is
connected.)
2
Direct Monitor Settings
IN 1-2 and IN 3-4 (US-4x4 only)
Set the monitoring signal for the IN1-IN2/IN3-IN4 jacks to
“Mono” or “Stereo”.
o
When set to “Mono”
Stereo signals sent to the computer remain unchanged,
but are output as mono signals from the LINE OUT
(BALANCED) and PHONES ( 1 and 2 jacks on US-4x4)
jacks.
o
When set to “Stereo”
Stereo signals sent to the computer remain unchanged,
and are output as stereo signals from the LINE OUT
(BALANCED) and PHONES ( 1 and 2 jacks on US-4x4)
jacks.
3
Audio Input items
Turn input on/off for each channel separately.
o
Turn an input on by putting a check in its checkbox
.
When an input is on, signals on that channel will be input.
o
Turn an input off by removing the check from its checkbox
. When an input is off, signals on that channel will not
be input.
4
Line Outputs items
LINE OUT 1-2
i
Select the signals output from the unit’s LINE OUT 1-2
and PHONES ( 1 and 2 jacks on US-4x4) jacks.
LINE OUT 3-4 (US-4x4 only)
i
Select the signals output from the unit’s LINE OUT 3-4
jacks.
Options
“Monitor Mix”
The signals from the channels selected using the
Audio Input On/Off items and the signals sent from
the computer by USB are mixed using the MONITOR
BALANCE knob. This mix is output from the LINE OUT 1-2
and PHONES jacks.
“Computer Out 1-2”
Only the “Computer Out 1-2” signals sent from the
computer by USB are output from the LINE OUT
[BALANCED] and PHONES jacks.
”Computer Out 3-4 (US-4x4 only)“
Only the “Computer Out 3-4” signals sent from the
computer by USB are output from the LINE OUT
[BALANCED] and PHONES jacks.
NOTE
Set the
MONITOR BALANCE
knob all the way to the left
(INPUT)
to monitor only the input channel signals and set it
all the way to the right
(COMPUTER)
to monitor only signals
output from the computer. At other positions, both signals
will be mixed.
5
Auto Power Save ON
When this setting is on, if operating in standalone mode and
no input signal (above −60 dBFS) has been detected for 30
minutes, the unit will turn itself off (start standby) automati-
cally.
o
Putting a check (
4
) in the checkbox will turn the
automatic power saving function on so the unit will
automatically turn off (enter standby mode).
o
Removing the check (
4
) in the checkbox will turn the
automatic power saving function off.
