6
Assembly of your Tarpan Electric Scooter
1. Unpack the scooter and inspect all the parts to ensure nothing is missing. Be sure to have
someone else help you handle the scooter out of the box. Place your scooter on a flat, clean
surface. Place a block of 3.5’’ under the front, by the battery. This will make it easier for the
next step.
2. Insert the front part of the scooter into the connection tube of the platform and align
the bolt holes.
3. Slide the two bolts through the holes connecting tube and neck. Twist the bolts, do not
hammer them through.
4. Tighten the bolts and nuts using the 2 Allen wrenches in the tool kit. Also tighten the
small bolts on the outside of the tube clamp securely. Note : some models may have hex
bolts instead. Remove the support block so that the scooter rests on its three wheels.
Installing the Handlebar
1. Extend the handlebar tube to full upright position and insert it into the connection hole on
the front forks.
2. Ensure the handlebars are facing front with the brake on the left and the throttle on the
right, then tighten the handle bar hex bolts securely.
3. Pass the cables through the hooks provided for this purpose.
2
3
4
1
3
