7
ADJUSTMENTS.
FACTORY SETTINGS
To delete all settings and sensor memory, use a small
paper clip to poke through the hole between the
POWER
button and the USB charging port. You will feel a small
click when you press the reset button. The display will
default to the original factory setting and no Sensors will
be programmed to the Pager.
DISCONNECTING SENSORS
Removing Sensor Connections
You can reset your Pager to remove all the Sensors that
are connected to it.
•
With the keypad unlocked, press the
MODE
and
UP
key at the same time and then release.
•
While in programming mode, use the
DOWN
button
to select the zone you want to disconnect. If the
display reads “Use”, the zone is occupied by a Sensor.
•
To delete the Sensor from the zone, press and hold the
MODE
button for 2 seconds.
•
Press the
MODE
and
DOWN
button at the same time
and release. The display will now show “Add” and
“Code Learning” for that zone. You can either program
a Sensor to that zone or continue on by pressing the
DOWN
button to move on to the next zone.
LOW BATTERY ALERT IN SENSOR
•
If a Sensor has a low battery then the Pager display will
read “Low Battery” when a signal is received from that
Sensor.
•
Follow the instructions of the Sensor for advice and
guidance on changing the battery.
