08
Functions, inputs & outputs
FREQ.:
Set the Bass Boost center frequency, from 35Hz up to 55Hz.
5 - MONITOR:
Connection to an accessory, which function is to monitor the amplifier and it is where
all information from the indicator LEDs, such as distortion (CLIP/TEMP) and protection actuation
(PROT), will be displayed simultaneously.
(Accessory included in PREMIER model only).
1 - INPUT (R and L):
Inputs of signals to be amplified. Connect these signals to RCA outputs of Head Unit ,
using good quality shielded cables to avoid noise influence.
2 - LEVEL:
It sets the amplifier input sensitivity, which allows an optimal adjustment to the output signals
levels of nearly all models of Head Unit found in the market.
HIGH PASS:
Variable adjustment from 10Hz to 90Hz, which determines the beginning of the amplifier
operating frequency.
LOW PASS:
Variable adjustment from 90Hz to 10KHz, which determines the end of the amplifier
operating frequency.
3 - CROSSOVER
4 - BASS BOOST
BOOST
: Boost for bass levels in 50Hz, with variable gain up 0 to +10dB.
6 - SPEAKER:
Output (positive and negative) to transducers connection (speakers). Follow the polarity
described and the minimum impedance recommended.
To combine speakers, the resulting impedance must be taken into consideration.
See the examples below:
7 - REMOTE TERMINAL:
The remote Head Unit output must be connected by a 0,75mm² (18 AWG) cable.
4 OHMS
4 OHMS
Resulting
impedance:
2 OHMS
Amplifier 2 OHMS
2 OHMS
2 OHMS
Resulting
impedance:
1 OHM
Amplifier 1 OHM
SPEAKER
INPUT
MONITOR
MAX.
LEVEL
0
BASS BOOST
BOOST
+10
0
dB
FREQ.
55
35
Hz
Hz
LOW PASS
90
10
CROSSOVER
HIGH PASS
10KHz
90
1
2
3
4
5
7
6
Summary of Contents for MD5000.1 Premier
Page 1: ......
Page 12: ...MN_510007167_R00 ...
