Taramps Electronics SMART 3, Instruction Manual

Page: 11 / 14

4 - NEGATIVE POWER SUPPLY: Use a cable of minimum 4 AWG up to maximum of 1/0 AWG as short as possible,
connected to the negative battery pole.
1 - SMART COOLER: This amplifier has two internal ventilation coolers, which cannot be obstructed. Controlled
by an intelligent system (Smart Cooler), it only operates at full speed when needed, ensuring longer cooler life
and a quieter operation of your amplifier. For a perfect operation, the amplifier must be installed in a dry and airy
place. We recommend not embedding it, in order to ensure adequate ventilation.
2 - POSITIVE POWER SUPPLY: Use a minimum 4 AWG up to maximum of 1/0 AWG cable direct from the
positive battery terminal, with fuse or circuit breaker (150A), as close to it as possible.
3 - TERMINAL REMOTE: It must be connected to the remote output of the head unit using a 18 AWG cable.
In case of power bus bar using, avoid tightening with extenders on the allen wrench, as excessive torque may
break the the terminal.
We recommend that all cables have tinned ends for better electrical contact.
10
Power supply connector
LEDS indicators & protection system
Working
amplifier
Battery with voltage
below 9V
Battery with voltage
above 16V
Temperature above operating
limit (> 85 ° C)
If it goes into protection, the amplifier will automatically restart.
The thermal protection waits for cooling before restarting.
Low Battery Protection: Working amplifier Red LED (LED Monitor) or Smart LEDS, flashes 2x Red LED
(LED monitor) or Smart LEDS, flashes 2x Amplifier restarts.
Example:
POWER
INPUT
1 1 2 3 4
Led of Monitor
Conditions Smart LEDs
On - Displays audio
level.
LEDs flashing 2x
LEDs flashing 3x
LEDs flashing
6x per second
Continuously
LEDs flashing
1 second on
1 second off
Blue LED on
Red LED
flashes 2x
Red LED
flashes 3x
Red LED
flashing 6x per
second continuously
Yellow LED
flashing 1 sec. on
1 sec. off
2x
3x
Short circuit on output or
between output terminal to GND
ENGLISH