10
Safety requirements
Introduction
Taramps reserves the right to modify the contents of this document at any time without prior notice and does
not have the obligation to apply the changes in units which were previously produced.
As you read this manual, pay attention to the safety symbols.
Safety
This symbol with
“CAUTION”
is intended to alert the user to the presence of
important instructions. Failure to heed the instructions will result in risk of
injury to user or product damage.
CAUTION
Read this manual before preparing the product. In case of doubt, contact our technical
support: (
18) 3266-4050
or
www.taramps.com.br.
At the end of its useful life, this product must not be disposed of in household
waste. Look for an electronic equipment collection or recycling center for proper
disposal.
-
The installation of this amplifier must be done by a qualified professional.
-
Wear safety glasses, insulated gloves and correct tools for installing this product.
-
This amplifier must be installed in a firm place with at least 1” space around the heatsink for
proper heat spreading.
-
Never install the amplifier in places exposed to dust, humidity and water. Pay attention to
install it far from fuel tank, fuel lines, heat sources and other parts of vehicle.
-
Check carefully the polarity of power supply wiring (battery's positive and negative
terminals) loudspeakers and the minimum speaker impedance;
-
Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect
any wires routed through car's body.
-
Before make any connection to amplifier, disconnect the battery negative terminal.
-
When in use, the external surface of may amplifier becomes hot. Avoid touching the heatsink
area and keep childrens far from the amplifier.
-
This amplifier may produce high sound pressure levels. Avoid continuous exposure to levels
over 85dB to prevent permanent hearing loss.
To ensure proper use, please read through this manual before using the amplifier. It is
specially important that you know the
WARNINGS
and
CAUTIONS
contained here.
-
Output connections for speakers may have voltage levels when the amplifier is operating.
Make sure that the amplifier is turned OFF before proceed any connection or disconnection in
this terminals.
-
If you want to dispose this amplifier, don't throw it on domestic waste. It must be collected by
an used electronic product disposal service for proper recycling.
-
It is compulsory to install fuses to protect against overloading. The fuse or circuit breaker
must be installed as close as possible to the battery and sized up according to the amplifier;
