TAPO-FIX CB 75 N, Manual

Page: 2 / 2

6. Inserting the wallpaper
Open up the top, turn the paste roller till it‘s fully wetted with paste.
Lay down the wallpaper on the roller.
Lead wallpaper on the roller to the wallpaperholder and close the top.
Important: Make sure that the back of the wallpaper runs over
the roller
7. Paste the wallpaper
Pull the wallpaper to the seperating rail, set the CB Counter to „Zero“.
Tilt the corners and pull the wallpaper parallel to the table edge to the
favored measure. If the length is longer then the table, fold the length
and pull it to the favored measure. When working without the CB Counter
measure the lenght from the seperating rail.
For pattern wallpaper, cut before the pasting or use the pattern table
inside the top of the Pasting Machine.
8. Cut the wallpaper (with Seperating knife or Sliding cutter)
Pull the Cutting Knife or the Sliding Cutter under light preasure through
the Cutting Rail. Afterwards fold the wallpaper.
Closure
cap
Cleaning
Slider
10. Accessories for Pasting Machine CB 75 N
- Equipment-Table 75 N, Item-No. GT75N
- Wood Case 75 N, Item-No. HK75N
- Sliding cutter 75-800, Item-No. SW75-800
- CB Counter, Item-No. MZCB
and CB 1000 N
- 1000 N, . GT1000N Equipment-Table Item-No
- 1000 N, . HK1000N Wood Case Item-No
- 1000, . SW1000 Sliding cutter Item-No
- , . MZCB CB Counter Item-No
Accessories (not included): CB Counter, Sliding cutter 75-800
Accessories (not included): CB Counter, Sliding cutter 75-800
CB Counter
Accessories (not included): CB Counter, Sliding cutter 75-800
Cutting
Rail
tapo-fix GmbH & Co. KG
Meinstraße 114
Telefax: +49 5363 9771-50
D-38448 Wolfsburg e-mail: info@tapofx.de
Internet: www.tapofix.de
Telephone: +49 5363 9771-0
9. Cleaning the Pasting Machine
During daily use Pasting Machine must not be cleaned. Only under heavy
pollution or before a longer break before the next use, the Pasting Machine
should be cleaned with cold water. After draining the paste and unmounting
the top, remove the paste roller from the machine.
By simultaneously turning the roller and pushing the hand under it, the roller
will pop out of the holder
Important: Turn the adjusting knob to the end before removing the roller,
as well before longer breaks, to make sure theres no paste at the scraper.
Sliding
Cutter
Cutting
Rail
Cutting
Knife