FAST-18 Pole-Mount Radar Speed Display Sign user Manual
6
Note:
If the Timer is enabled, (see
“Setting the Clock and Timed Events”
) the sign will run in Violator Mode
(or any other mode) only during the selected event timed program. Otherwise, if the timer is disabled,
the sign will run continuously (not recommended for overly long periods of time when on battery
power only).
VIOLATOR ALERT 1: MS - MINIMUM SPEED
After seeing the “VA” screen, the display will show “MS” (see photo below)
along with a number. The number represents the lowest speed at which
the display will start showing all oncoming vehicles. When this number
appears, the operator has 5 seconds within to start pushing the button in-
order to program this “MS” speed setting. Press the button until the desired
speed setting is reached.
Note:
If the button is held down, the numbers will increment FAST without having to press the button many
times. The numbers will start over after 99 if you miss your desired speed without turning off the power.
If using the key chain remote, simply press either button to move the numbers forward or backward.
Once the desired setting is reached, stop and wait for the next screen to appear after approximately 5 seconds.
The screen will then change to the next screen for speed setting.
VIOLATOR ALERT 2: SL - SLOW DOWN
The display will now show the “SL” (Slow Down) message and flashes with the
desired speed setting number speed setting number. The red “Slow Down”
message is effective in helping to calm traffic. When the operator sees the
setting number appear, push the button within 5 seconds in-order to change
this number until the desired speed setting is reached.
Note:
You can set the numbers even when the words “Slow” are flashing.
Once the desired setting is reached, stop pressing the button and wait for the
next screen, after approximately 5 seconds.
VIOLATOR ALERT 3: RB - RED AND BLUE FLASHING LIGHTS
The display will now show “RB” which effectively flashes the Red and Blue flashing
light pattern at the driver while displaying their speed. The operator has 5
seconds to start pushing the button in-order to change the number setting.
Note:
You can set the numbers even when the “Red & Blues” are flashing.
Press the button until the desired speed setting is reached. Once the desired
setting is reached, stop and wait for the next screen after approximately
5 seconds.
VIOLATOR ALERT 4: LF - FLASHING WHITE STROBE
The display will now show “LF”. When drivers go over this setting, the white
flashing strobe. The operator has 5 seconds to start pushing the button in-
order to change the speed setting. Press the button until the desired speed
setting is reached. Once reached, stop and wait for the next screen to appear
after approximately 5 seconds.
“Minimum Speed”
“Flashing White Strobe”