13
ENGLISH
Warranty
This product is covered with TaoTronics product and labor warranty for 12 months from the date of
its original purchase. If any problems occur, please contact the TaoTronics Customer Care Centre via
the contact information listed in this User Guide.
We can only provide after sales service for products that are sold by TaoTronics or TaoTronics
authorized retailers and distributors. If you have purchased your unit from a different place, please
contact your seller for return and warranty issues.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Remote control does not
respond to the lamp
Remote control is not paired
with your lamp automatically
The remote control is already
paired with your lamp
by default. If not, please
manually pair as instructed
below.
1. Press and hold both
buttons on Lamp Controller
for more than 1 second, both
lamps will flash indicating it is
under pairing mode now.
2. Press and hold the Power
button on Remote Control
until both lamps stay solid
on. Then your lamp is
successfully paired with the
remote control.
Clear Pairing History
Remote control is missing
or more than one remote
controls are connected
To disconnect the paired
remote control(s),
1. Press and hold both
buttons on Lamp Controller
for more than 1 second, both
lamps will flash.
2. To clear all pairing history,
press and hold the Main
Lamp button on Lamp
Controller for more than 3
seconds until both lamps
turn off.
3. To cancel one of the
remote controls, press and
hold the Power button on
Remote Control until both
lamps turn off.
