Preparation & Operation
Before Each Use
Connect the outlet of your pressure washer to the inlet port of the trigger gun of the wand
using appropriate quick couplers or fittings rated to handle high pressure.
Connect appropriate extension wands(Item2/3/4) to the outlet fitting of the telescoping wand.
And the extension wand quick connects an intended spray nozzle tip.
Be sure all fittings are tight. If there is leakage, please be sure use enough teflon tape.
After Each Use
Relieve pressure before disconnecting gun from pressure washer hose.
Perform the following inspections after each use to clean the wand and ready it for the next use.
•Clean out any dirt or foreign material from the top. If necessary, use a cloth or sponge to
wash the telescoping wand and rinse it with tap water.
•Check for loose parts and any damage.
•Fully retract, and store in safe place.
Operating Instructions
To Extend the Wand
Lift the lever locks rings and pull the wand out to the desired length. Clip the locks firmly
to hold the wand at the desired length.
To Retract the Wand
Lift the lever locks and slide the extension segment into the wand until the desired length
is reached and clip the locks firmly to hold the extension segments in place.
To Begin Spraying
Start the pressure washer. Raise the wand and keep the nozzle at least ten feet away
from the surface to be cleaned. Squeeze the trigger to begin spraying, maintain stable
footing, and move the wand in to the surface to be cleaned.
To Stop Spraying
Before releasing the trigger gun move the nozzle at least ten feet away from the surface
being cleaned and make sure you have solid footing. The wand will rebound when the
trigger is released or if pressure is lost. When you are clear of the work surface and in a
safearea - release the trigger.
Wand Use & Care
•Do not force the product. Products are safer and do a better job when used in the manner
for which they are designed. Plan your work, and use the correct product for the job.
•Check for damaged parts before each use. Carefully check that the wand will operate
properly and perform its intended function. Replace damaged or worn parts immediately.
Never operate the product with a damaged part.
•Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled
with the power switch is dangerous and must be repaired by an authorized service
representative before using.
•Disconnect the power/air supply from the product and place the switch in the locked or
off position before making any adjustments, changing accessories, or storing the tool.
Such preventive safety measures reduce the risk of starting the tool accidentally.
•Store the product when it is not in use. Store it in a dry, secure place out of the reach of children.
•Inspect the tool for good working condition prior to storage and before re-use.
•Keep guards in place and in working order. Never operate the product without the
guards in place.
•Do not leave the tool running unattended.
Operation Warnings
•DO NOT exceed the rated PSI capacity.
•Never use near power lines.
•Never extend or retract the wand while spraying or while under pressure. Stop the
equipment and relieve pressure before making any adjustments to the wand.
•Never change nozzles or accessories while under pressure. Stop the equipment and
relieve pressure before making any changes.
•Never use while on ladders or scaffolding.
•Never use with unapproved accessories.
•Never exceed rated pressure or volume.
•Never use high-pressure to clean persons or animals.
•Never remove or alter warning labels or identification tags.
•Never use wand if damaged.
•Always read, understand, and follow operation instructions.
•Always maintain proper balance and control of extension wand.
4
5
