TANOS MW 1000, Original Operating Instructions

Page: 12 / 40

[1-6]
[1-7]
[1-8]
[1-9] Foot
T-Loc
lock
Plate
Slide element
The specified illustrations appear at the begin­
ning of the operating manual.
4 Technical data
MW 1000 Basic
Dimensions
(width x length x height) 600 × 641 × 1076
mm
Maximum load 100 kg
Maximum load
(plate) 100 kg
Weight 19 kg
5 Intended use
The MW 1000 mobile workshop is intended for
securely transporting
systainer®
and accesso­
ries, as well as for mobile working. The worktop
can be extended using the TSB/1-MW 1000
plate. Workpieces can be clamped securely on
the worktop using the clamping systems inclu­
ded in the range of accessories. This turns the
table into a workbench for numerous manual
tasks such as planing, grinding and cutting,
among others. The mobile workshop is not de­
signed for outdoor use and has only limited
protection against weather influences.
The user is liable for improper or non-in­
tended use.
6 Assembly
Figure
MW 1000 Basic
[2-1]
SYS-AZ-MW 1000
[2-2]
TSB/1-MW 1000
[2-3]
7 Working
7.1 Adjusting the cutting depth for sawing
Ensure that the cutting depth is always correct­
ly set to the thickness of the workpiece. We rec­
ommend that you set the cutting depth to a
maximum of 5 mm greater than the thickness
of the workpiece. This will help you to avoid
damaging the profile frame.
7.2 Turning the perforated top
After the perforated top has worn down, you
can turn it round. To do this, undo the four
screws in the corners in the underside of the
table.
8 Accessories
The order numbers of the accessories and tools
can be found in the
TANOS
catalogue or on the
Internet at "
www.TANOS
.
de
".
9 Environment
Do not dispose of the device in the
household waste!
Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
English
11