8
Dante Bridge Operation Manual rev 2.1.0
10. Audio routing
10. Audio routing
The Dante Bridge can use one or two audio channels from the Dante stream. Normally the unit would be
configured to route channels to Input 1 and Input 2. You may see an option to route to channels 3 and 4;
however, these are not used in the product. Audio routing is accomplished using the Dante Controller
application. You may find it helpful to name all Dante devices to clarify routing.
11. Rack mounting
The Dante Bridge and accessory power supply may be used free-standing. If you wish to mount them in a
19-inch rack, then the Accessory Mounting Kit may be used (Tannoy part no. 8001 4470).
Please note that this product generates some heat, which is normal. However, to prevent over-
heating, allow for a free flow of air around the unit. Do not stack units on top of one another.
To mount an Accessory in the Mounting Kit panel:
1. Remove the two mounting brackets and Lexan
blanking sheet which are covering the aperture
you wish to mount the Accessory in, by removing
the two nuts. (Keep these and the screws and
washers).
2. Remove the two screws from one side of the
accessory.
3. Using the two screws removed in 2, attach one
mounting bracket loosely to the side of the
Accessory, with the ‘ear’ towards the front,
pointing outwards
4. Repeat 2 and 3 for the other side. Now push the
lid towards the back of the unit as far as it will go
then align the bracket ears with the front edge of
the lid. Now tighten the screws.
