Tannoy CVS6, Quick Start Manual

Page: 3 / 19

4
CVS Series Quick Start Guide
5
(EN)
Introduction
Thank you for purchasing this Tannoy Ceiling loudspeaker. This product range is suited for high-level music and speech reinforcement applications requiring
exceptional sonic quality with uncompromised reliability.
Unpacking
Every Tannoy product and accessory is carefully inspected before packing. After unpacking, please inspect your product to make sure no damage has occurred in
transit. In the unlikely event of any damage, would you please notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return
the faulty unit to them for inspection. Each CVS loudspeaker is packed in pairs and provided with the following accessories as standard; C Ring, tile-bridge kit, grille,
cut-out template, and paint mask. A plaster (mud) ring is also available as an optional extra.
Safety Notices
Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to provide security of a backup support. A secondary
support line should be attached from the safety loop on the rear of the product, to a source point on the ceiling. Please consult the relevant construction codes
in your region. When using a power driver to install the product it is essential to use the correct torque level settings to avoid over tightening and damage to the
ceiling material or clamps. Recommended torque setting: 1.5 Nm. Tannoy will not be held responsible for any damages caused by the improper installation of these
loudspeakers. Electrical Safety Notice: To comply with the standard UL1480, metal-clad flexible conduit (BX) is required for connection to the terminal block for proper
earth grounding.
SAFETY NOTE :
In order to comply with the relevant fire safety regulations (ie. BS 5839: 1998), it is required that in the event of fire, that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is complete. Suitable measures include: - a) use
of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example constructed from ceramic materials; b) use of terminal blocks of a lower melting point but protected with thermal insulation; c) use of terminal blocks such that, on melting, an
open-circuit or a short-circuit does not occur.
Product Feature Identification
Safety Tab
Mounting Wings
Conduit/Cable
Clamp
CVS 6
Rotary Switch
Tuning Ports
Screws for
Mounting Wings
Safety Tab
Mounting Wings
Conduit/Cable
Clamp
CVS 8
Screws for
Mounting Wings
Rotary Switch
Tuning Ports
Safety Tab
Mounting Wings
Conduit/Cable
Clamp
Rotary Switch
Tuning Ports
Screws for
Mounting Wings
CVS 4/CVS MICRO
Safety Tab
Conduit/Cable
Clamp
Mounting Wings