6
3. Assembly Instructions
3.1. Cut-Out
The cut-out size required is 210mm.
3.2. Connections
The CMS50 ICT is provided with a pluggable European type connector, which is
located on the back of the speaker can, under the wiring cover as shown in Figure 3a
below. This consists of a plug and socket. The plug can be removed from the socket
(Figure 3b) for wiring.
Figure 3a Figure 3b
To cable is inserted into the hole on the side of the plug, and the screw is tightened to
secure the cable in the plug. The plug is wired to the amplifier such that the
connections are as follows:
Pin 1 is Positive - connect to Red
Pin 2 is Negative - connect to Black
For additional speakers, pin 3 and 4 are in parallel with pins 1 and 2, where:
Pin 3 is Positive
Pin 4 is Negative
Before connecting the speaker, ensure the wiring cover and cable clamp on the back
of the can are open as shown in Figure 3c. Connect the wired plug into the socket.
Figure 3c
Once the plug has been connected, close the wiring cover as shown in Figure 3d,
below:
Summary of Contents for CMS50
Page 1: ...CMS50 CMS50T ICT USER MANUAL HOLE CUT OUT SIZE 210mm 21210mm ...
Page 2: ...2 ...
Page 9: ...9 Figure 3g ...
