Eng
7
Eng
6
5) Carefully step off WB-8000RW after measurement is
complete.
Note:
•If you do not step off the scale within 30 seconds of
weighing, the WB-8000RW LED will be lit red and
emit two short beeps to remind you to step off the
scale.
When data output ends, the WB-8000RW LED will turn off,
and when you step off the WB-8000RW, it will switch to
standby mode (the LED will blink green in 4 second
intervals).
6) When the D-8000 display disappears, the scale can be used
for weighing again.
The value shown on the D-8000 will disappear, and after
switching to standby display, the unit will beep, and “-----”
will be shown on the display.
When the WB-8000RW starts up, beeps, and switches to
measurement mode (the LED will blink green in 1 second
intervals), please step onto the WB-8000RW.
Note:
•If no measurement signal is received by the D-8000
from the WB-8000RW for a certain amount of time, the
D-8000 display value will disappear. When this
happens, the WB-8000RW will switch to standby mode
(the LED will blink green in 4 second intervals).
* To end measurement, press the D‐8000 OFF key to turn
off the display. Switch the WB‐8000RW mode selection
switch to the OFF position.
d
d
d
Measurement Ended
d
<LED: Blinking Green (4 Second Intervals)>
<LED: Blinking Green (1 Second Intervals)>
Pi
d
2. BMI mode
Press
to enter your height in cm.
Note:
•When the weight display unit is set to “pounds”, enter your height in inches.
2) Once you have finished entering your height, press
.
3) Step onto the WB-8000RW.
Note:
•Enter your height within 30 seconds of the D-8000 displaying “-----”.
4) After weighing, the D-8000 will display your weight and BMI.
3. Changing Units
You can change units by pressing the kg/lb key when the D-8000 displays “-----”.
Note:
•This function may not be available for all models.
4. Output Function
• When the WB-8000RW’s mode selection switch is set to ON, both
wireless and USB output can be used. USB transmission will be set to
output-only, and when the display is set your weight and BMI will be
automatically output. The LED will be green.
The WB-8000RW’s output function is controlled by the mode selection switch’s position.
d
d
d
d
d
d
1) After step 3 “Press
on the D-8000” of the “Standard Weighing Procedures”, the top half of the
LCD will display “-----”. Press
.
The bottom half of the LCD will blink “170” (when the unit is set to “kg”).
• When the WB-8000RW’s mode selection switch is set to USB ONLY, only
USB output can be used. USB transmission will be possible in both
directions (input and output). The LED will be blue.
LED: Green
LED: Blue
