Controls & Instrumentation
The Aircraft has some of the standard Tango 2
instrumentation along with some additional
components. Please consult the list below for a
complete list of instruments and controls.
Note that this list is “as-built.” Changes to this list (if
any) will be found in the Airframe Log and/or Engine,
Prop & Rotor Log.
Flight Controls
Rotor Control Cyclic (front and rear seats)
Rudder Pedals (front and rear seats)
Throttle (front and rear seats)
Wheel Brakes (front seat only)
Electric Rotor Brake (front seat only)
Electric Pre-rotator Control (front seat only)
Instrumentation
Airspeed Indicator ASI (front seat only)
Altimeter (front seat only)
Vertical Speed Indicator VSI (front seat only)
Compass (front seat only)
Yamaha Engine Monitor (front seat only)
Digital Engine RPM
Speed Sensor (used for Rotor RPM*)
Fuel Indicator w/low fuel lamp
Diagnostic Code Display
Engine Warning Light
VHF Radio w/Intercom (front and rear seats)
Hobbs Meter (front seat only)
Digital Volt Meter
Running Lights
Strobe Lights
2
Instrumentation (continued)
Landing Lights
Rotor Brake Status Lights (front seat only)
Pre-rotator Status Lights (front seat only)
USB and Lighter Power Ports (front seat only)
Keyed Master Switch (front seat only)
Independent Ignition Switch (front seat only)
Push-button Starter Switch (front seat only)
Electric Rotor Trim (front cyclic only)
Radio Push-to-talk PTT (front and rear seats)
Intercom Push-to-talk PTT (front and rear seats)
GA headphone/mic jacks (front and rear seats)
Instructor panel (rear seat only)
Switch/Breaker Panel (front seat only**)
*
Rotor RPM displayed on Yamaha Speed Sensor
requires a multiplication factor for accurate rotor
RPM.
**
Additional fuses are located in the wiring harness
behind the rear seat and in the relay mounted above
the battery.
3