7
SETTING HARDWARE
Fig.12
• Remove the table plate.
• Insert upper die into the ram hole and tighten the thumbscrew. Insert
lower die into base hole and tighten thumbscrew. (sold separately)
• Adjust ram height setting based on leather thickness.
• Load hardware into upper and lower dies, insert leather and pull the
handle down completely.
HOLE PUNCHING
Fig.14
• Remove the table plate.
• Screw desired punch tube or chisel into the adapter.
• Insert adapter into the ram hole and tighten thumbscrews.
(sold separately).
• Insert anvil into base hole and tighten thumbscrew.
• Adjust ram height setting base on the tube or chisel height.
• Place workpiece on the anvil and pull the handle
down completely.
WARNING:Keep hands and fingers clear
of moving parts to avoid injury.
STAMPING
Fig.13
• Install the table plate and reposition it to desired location.
• Insert stamp adapter or type holder (sold separately) into the ram hole
and tighten thumbscrew.
• Adjust the ram height base on the leather thickness and desired
impression depth.
• Place workpiece onto table plate and moisten before stamping.
• Pull handle down completely.
Fig. 12
Fig. 14
Fig. 14
Upper Die
Punch
Adapter
Stamp Adapter
Lower Die
Anvil
Stamp